In-/Output
-
Incl. 19% Tax, excl. Shipping Cost€29.99
- Measure power, voltage and current up to 720W/36V/20A
- 1mW, 1mV, 1mA resolution over the whole range
- Bidirectional current measurement (e.g. charge/discharge)
- Configurable averaging and ADC conversion time
-
Incl. 19% Tax, excl. Shipping Cost€27.99
- Measures temperature with a thermocouple
- Supports B, E, J, K, N, R and T type
-
Incl. 19% Tax, excl. Shipping Cost€6.99
- Galvanically isolated switching of large AC or DC loads
- For example: motors, pumps and lamps
- Bricklet controls Solid State Relays (SSR)
- The offered SSRs can switch up to 380V/25A AC or 50V/80A DC
- PWM possible (dimming of lamps, control speed of motors)
- Galvanically isolated switching of large AC or DC loads
-
Incl. 19% Tax, excl. Shipping Cost€49.99
- Drives one bipolar stepper motor over USB (max. 46V, 1.6A per phase)
- Noiseless operation of stepper motors
- Position, velocity and acceleration controllable
- Stepper resolution from full-step to 1/256-step
- Two configurable GPIOs for end-stops or similar
-
Incl. 19% Tax, excl. Shipping Cost€40.00
- Controls up to 10 RC Servos
- Brushless motors with external ESC also controllable
- Adjustable Period and pulse width
- Uses motion planning to reach position with smooth motion
- Velocity and acceleration/deceleration can be configured
- Current measurement for each individual channel
-
Incl. 19% Tax, excl. Shipping Cost€34.99
- Supports low-level RS485 as well as Modbus RTU master/slave
- Modbus RTU implementation is fully compliant for reading and writing of coils and registers
- Supports full- and half-duplex
- Configurable baudrate, parity, stop bits and word length
- Switchable 120 Ohm termination
-
Incl. 19% Tax, excl. Shipping Cost€21.99
- Sends and receives serial data
- Provides RS-232 and UART-TTL interface
- Configurable baudrate, parity, stop bits, word length and flow control
-
Incl. 19% Tax, excl. Shipping Cost€18.99
- Wireless house automation
- Controls remote mains switches (supported devices)
- Can control remote mains switches with dimming function
- Can read out the remotes of remote mains switches
-
Incl. 19% Tax, excl. Shipping Cost€59.99
- Controls one brushed DC motor with max. 36V and 10A (continuously)
- Direction, velocity and acceleration controllable
- Two configurable opto-coupled GPIOs for end-stops or similar
- Status, error, direction and GPIO LEDs
- Configurable overtemperature and overcurrent callbacks
-
Incl. 19% Tax, excl. Shipping Cost€14.99
- 1-wire communication with any 1-wire capable device
- Offers high-level commands (bus search, reset, write, read, write command)
- Supports 3.3V, 5V and external supply voltage
- Supports up to 64 1-wire devices simultaneously
-
Incl. 19% Tax, excl. Shipping Cost€29.99
- Can read and write NFC Forum Type 1, 2, 3, 4, 5 and Mifare Classic tags.
- NDEF definitions can be directly read/written with API.
- Supports NFC P2P mode
- Supports card emulation mode
- Range is restricted to 10cm (3.94")
-
Incl. 19% Tax, excl. Shipping Cost€14.99
- Capacitive touch sensor
- Can handle up to 12 electrodes used as touch locations
- Touch can be detected through a thin layer of glass/plastic/paper
- Size and placement of touch area can be user defined
- Can be used to build custom touch panels
-
Incl. 19% Tax, excl. Shipping Cost€12.00
- 4-channel digital input/output
- Fixed 3.3V logic voltage
- Configurable pull-ups and interrupts
- PWM output with frequency up to 32MHz
-
Incl. 19% Tax, excl. Shipping Cost€16.99
- 16-channel digital input/output
- Switchable logic voltage 3.3V or 5V*
- Configurable pull-ups and interrupts
-
Incl. 19% Tax, excl. Shipping Cost€34.99
- 4 Channel Solid State Relay
- Switch up to 30V with 0.6A
- Galvanically isolated
-
Incl. 19% Tax, excl. Shipping Cost€27.99
- Supports Pt100 and Pt1000 sensors
- Supports 2-wire, 3-wire and 4-wire type
- Measures temperature with 0.05% accuracy at the full scale of -246 to 849°C
- Resolution of 0.03125°C (15bit), output in 0.01°C steps
-
Incl. 19% Tax, excl. Shipping Cost€16.99
- Two relays for switching AC/DC devices
- Switches up to 240VAC/10A and 30VDC/7A
-
Incl. 19% Tax, excl. Shipping Cost€40.00
- Independently measures two voltages between -35V and +35V (DC)
- 24bit ADC for high resolution
- Individually calibrated
- Full-scale accuracy of 0.1% / ±4mV
- Up to 976 samples per second
-
Incl. 19% Tax, excl. Shipping Cost€11.98
- Two solid state relays for switching AC devices
- Switches up to 240VAC/1.2A (with max 12A surge current)
- Switching done during zero-crossing
-
Incl. 19% Tax, excl. Shipping Cost€16.99
- Two inputs that can detect the presence of 230VAC mains voltage
- State LED per input
-
Incl. 19% Tax, excl. Shipping Cost€24.99
- Precision current sensor, measures currents between 0 and 22.5mA
- Can read out any IEC 60381-1 type 2 and type 3 sensor
- High accuracy (0.15%), resolution (up to 0.172µA) and sample rate (up to 240 SPS)
- It is possible to detect if a sensor is connected/faulty
-
Incl. 19% Tax, excl. Shipping Cost€16.99
- 4 channel digital input
- Input voltages up to 36V (DC)
- Galvanically isolated
-
Incl. 19% Tax, excl. Shipping Cost€34.99
- 4 channel galvanically isolated frequency counter
- Configurable edge count per channel
- Measures duty cycle, period and frequency per channel
- Frequency range from 0.03Hz to 4MHz
- Time resolution up to 10.4ns and frequency resolution up to 0.03Hz
-
Incl. 19% Tax, excl. Shipping Cost€34.99
- Simultaneous programmable voltage and current output
- Outputs voltage between 0V and 10V (IEC 60381-1)
- Outputs current between 0mA and 24mA (IEC 60381-2)
- No external power supply necessary
-
-
Incl. 19% Tax, excl. Shipping Cost€21.99
- Enables energy monitoring of mains voltage (120V/230V AC)
- Measures voltage (V), current (A) and energy (Wh)
- Measures real/apparent/reactive power (W/VA/VAR)
- Measures power factor and frequency (Hz)
- Voltage and current waveform are provided
-
Incl. 19% Tax, excl. Shipping Cost€34.99
- Supports DMX slave and master
- Has male and female XLR connector
- All 512 DMX channels available
- Can be used to monitor existing DMX network without interference
- Switchable 120 Ohm termination
-
Incl. 19% Tax, excl. Shipping Cost€69.98
- Measures distances from 30cm to 500cm with ultrasound
- Resolution of 1mm
-
Incl. 19% Tax, excl. Shipping Cost€32.99
- Controls one brushed DC motor with max. 28V and 5A (peak) over USB
- API for many programming languages available
- Direction, velocity and acceleration controllable
- Configurable overtemperature and overcurrent callbacks
-
Incl. 19% Tax, excl. Shipping Cost€24.99
- Sends and receives data through CAN bus
- Configurable baudrate, modes and filters
-
Incl. 19% Tax, excl. Shipping Cost€16.99
- Generates a configurable voltage between 0V and 12V*
- Specification in 1mV steps (12bit resolution)
-
Incl. 19% Tax, excl. Shipping Cost€13.99
- Measures voltages up to 42V (DC)
- Full-scale resolution of ~10mV